Initial Setup
Phaser 6700 Color Printer 13
System Administrator Guide
Initial Setup at the Control Panel
System Administrator Access
If a system administrator has locked access to a control panel setting, a message appears when you
attempt to access the setting. The message prompts you to log in as an administrator.
1. Type admin and touch Next.
2. Type the administrator password and touch OK. The default password is 1111.
Manually Setting the Ethernet Interface Speed
The Ethernet interface on the printer automatically detects the speed of your network. Any auto-sensing
devices connected to the network, such as a hub, do not always detect the correct speed. Refer to the
configuration report to ensure that the printer detects the correct network speed.
1. At the control panel, touch Printer.
2. Touch the Tools tab, then touch Setup.
3. Touch Network & USB.
4. Touch Ethernet.
5. Touch Connection Speed.
6. Touch the appropriate speed for your network.
7. Touch OK.
Assigning a Network Address
The printer automatically acquires a network address from a DHCP server by default. To assign a static IP
address, configure DNS server settings, or configure other TCP/IP settings, see IP on page 21.
To Next Page
Loading...
