February, 2008
2-711
WorkCentre 5225, 5230
133-700 , 133-710
Status Indicator Raps
Launch Version
133-700 Staple/Punch Cancelled RAP
The Controller cancelled the Staple/Punch operation due to staple relationship with the print paper,
or during data format processing for fax receive document printing in the Controller.
Staple/Punch request is canceled to continue printing.
Procedure
Change Staple/Punch position designation or select paper according to Staple/Punch position.
133-710 Tray Select Fail RAP
Fax receive document is printed with bypass tray when tray inapplicable to Fax is selected.
NOTE: “Tray mode function in Declaration of Received Paper Size” is provided to select “From
which tray fax-received data shall be printed”. This error occurs when this function is set to
“Enable”.
Even when this function is set to “Disable”, this error occurs also in printing of fax report and
polling reservation document
*To automatically print received FAX/IFAX document, M/C automatically selects paper tray and
any of the following occurs when tray is selected:
-Selected tray is set as inapplicable tray to fax document printing. M/C selects then bypass tray
to continue printing.
-Paper size inapplicable to fax is set for selected tray. M/C selects then bypass tray to continue
printing.
-Paper type unusable for fax is set for selected tray. M/C selects then bypass tray to continue
printing.
-When error does not correspond to any of the above cases, selected tray may have failure.
*This error occurs also if any of the above four cases is detected “when customer manually
selects paper tray to print document from mailbox”.
Procedure
- To set paper size applicable to fax document printing.?
A3SEF, A4LEF, B4SEF, B5LEF, A4SEF, A5SEF, B5SEF, LetterSEF, Legal(14inch),
Legal(13inch), Ledger, LetterLEF and Half Letter SEF are applicable.
-To set paper type applicable to fax document printing.
Plain paper, Quality paper, Recycle paper, Used paper and user-defined paper are applicable.
-To take any of the following actions when “Tray mode function in Declaration of Received Paper
Size” is set to “Enable”:
(1) To add tray number that customer wants to designate for printing, to [Function setting]-->[FAX
operation control]-->[Tray mode].
(2) To select tray number to be used for printing by customer, among trays set for [Function setting]-
->[FAX operation control]-->[Tray mode].
- To contact FX Support Division when none of the above actions is effective.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
