Xerox WorkCentre 5765 - Page 131

Network Configuration
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
131
Device Model: 1
2. Press <Enter> to continue, and enter the following parameters:
Lan Attachment: *IP
Port Number: 9100
Online at IPL: *yes
Font Identifier: 11
Form Feed *autocut
Note: For some versions of AS400, the default may match some of these parameters.
3. Leave all other parameters at the default value, press <Enter>, and enter the following
parameters:
Activation Timer: 170
Inactivity Timer: *sec15
Host Print Transform: *yes
4. Press <Enter> to continue, and enter the following parameter: Manufacturer Type and Model:
*hp5si
5. Leave the remaining parameters set to their default values and press <Enter> to continue. Enter
the following parameters:
Remote Location: Enter the IP Address of the printer.
User defined options: *IBMSHRCNN
System driver program: *IBMSNMPDRV
6. Leave all other options set to the default values. Press <Enter>, A message indicates that you have
created the device Xerox printer.
7. Power on the device and start a print writer. Place a spool file in the appropriate queue to test the
printer.
AS400 Printing using LPR (CRTOUTQ) - Optional
Creating a remote queue (LPR) on the AS400
1. At the command line, issue CRTOUTQ and press F4, then F9 for additional parameters. The setup
is as follows:
Note: ONLY CHANGE THE PARAMETERS IN BOLD.
• Output queue: queue name
•Library: Library name
• Maximum spooled file size
• Number of pages: *NONE
•Starting time: Time
•Ending time: Time
• Order of files on queue: *FIFO
• Remote system: *INTNETADR
• Remote printer queue: virtual printer name**
Note: The queue for WorkCentre should be lp (lower case L and P).