T
ROUBLESHOOTING
8.13
8
Paper Jam 0
Paper has jammed in the
feeding area of the paper
tray.
Your machine detects non
feeding from the Bypass
tray.
Clear the jam. See page 8.4.
Load paper in the Bypass tray. Or
remove the jammed paper from the
Bypass tray.
Paper Jam 1
Paper has jammed in the
paper exit area.
Your machine detects non
feeding from the Bypass
tray.
Clear the jam. See page 8.7.
Load paper in the Bypass tray. Or
remove the jammed paper from the
Bypass tray.
Paper Jam 2
Paper has jammed in the
fuser area.
Clear the jam. See page 8.5.
Power Failure
Power has turned off then
on and the machine’s
memory has not been
saved.
You need to start again the job
which you were trying to do before
the power failure.
Retry Redial?
The machine is waiting for
a specified time interval to
redial a previously busy
station.
You can press
Enter
to immediately
redial, or
Stop/Clear
to cancel the
redial operation.
Stop Pressed
The
Stop/Clear
button is
pressed during a copy or
fax operation.
Try again.
Toner Empty
The toner cartridge has
run out. The machine
stops.
Replace with a new toner cartridge.
See page 7.8.
Toner Low
The toner is almost empty.
Take out the toner cartridge and
gently shake it. By doing this, you
can temporarily reestablish printing
operations.
Display Meaning Suggested solutions
To Next Page
Loading...
Need help?
General
