20
Manual Two-Sided Copying
(XD130df/155df only)
Important Tip: The WorkCentre has been configured to copy onto
8.5×11/A4 paper. When copying onto any other paper size the image may
not be placed properly. The default paper size for both paper trays is
8.5×11/A4.
You may want to change the default setting for one or both of the trays if
you find the factory settings do not meet your needs. Refer to
Customizing Your WorkCentre for information about changing the default
paper size.
Xerox
1
1. Place side 1 original face down on
the Document Glass, with the TOP
toward the LEFT. Lower the
document cover.
Note: 16 lb / 60 gsm copy paper is not
recommended for two-sided copying.
2. Select the desired 1-Sided/2-Sided
mode.
3. Select the quantity.
4. Press Start to make side 1 copies.
•
After scanning side 1, the light next
to the selected mode will flash to let
you know that the WorkCentre is
ready to scan side two.
Xerox
2
5. Remove the side 1 original and place
the side 2 original face down on the
Document Glass with the TOP toward
the LEFT. Lower the document
cover.
6. Press Start.
To Next Page
Loading...
Need help?
General
