49
Problem Solving
Problem Solving Chart
The following chart lists some conditions that may occur and the
recommended solutions. Follow the suggested solutions until the problem
is corrected. Refer to the Status Code Chart in this section for status code
information. If the problem persists, please refer to the Information
section for the appropriate telephone numbers.
Condition Suggested solutions
Ready indicator
does not light.
Check that the WorkCentre is plugged into an
electrical receptacle.
Ensure that there is power to the receptacle
and that the WorkCentre power is in the ON
position.
Copies are too
light or too dark.
If the original is light, select the lower copy
contrast position to darken the background of
the copies.
If the original is dark, select the upper copy
contrast position to lighten the background of
the copies.
Smears, lines,
marks, or spots
on copies.
If defects are on the original, press the copy
contrast key to lighten the background of your
copies.
If no defects are on the original, clean the
document glass and underside of the
document cover. (Refer to WorkCentre
Care.)
If the above solutions do not help, clean the
corotron wire. (Refer to WorkCentre Care.)
Copy image is
skewed.
Ensure that original is positioned correctly on
document glass.
Check that copy paper is loaded correctly.
Blank copies.
Ensure that the original is face down on the
document glass.
Check for a broken corotron wire. Refer to
WorkCentre Care section for the location of
the corotron wire.
To Next Page
Loading...
Need help?
General
