Xilinx Zynq UltraScale+ ZCU208 - Default Jumper and Switch Settings

Table 2: ZCU208 Board Component Locations (cont'd)
Callout
Ref.
Des.
Feature
[B]=Bottom
Notes
Schematic
Page
45 U115,
U116
ADC/DAC AVCC regulators [B] MPS MPM3683-7 56
46 U114 ADC AVCCAUX 2A regulator [B] MPS MPM3833C 57
47 U125 DAC AVCCAUX regulator [B] MPS MPM3833C 58
48 U118 DAC AVTT regulator [B] MPS MPM3833C 58
Default Jumper and Switch Settings
The following gure shows the ZCU208 board jumper header and switch locaons. Each
numbered component shown in the gure is keyed to the applicable table in this secon. Both
tables reference the respecve schemac page numbers.
Chapter 2: Board Setup and Configuration
UG1410 (v1.0) July 8, 2020 www.xilinx.com
ZCU208 Board User Guide 15
Send Feedback