Xilinx Zynq UltraScale+ ZCU208 - Page 20

1. Store a valid Zynq UltraScale+ RFSoC boot image le onto an SD card (plugged into SD
socket J23) connected to the MIO[39:51] SD interface.
2. Set the boot mode pins SW3 [4:1] as indicated in the table above for SD.
3. Either power-cycle or press the power-on reset (POR) pushbuon. SW2 is callout 11 in
Figure 3.
See the Zynq UltraScale+ Device Technical Reference Manual (UG1085) for more informaon about
Zynq UltraScale+ RFSoC conguraon opons.
Chapter 2: Board Setup and Configuration
UG1410 (v1.0) July 8, 2020 www.xilinx.com
ZCU208 Board User Guide 20
Send Feedback