Xinje DS5E Series

69
5.7 Speed control (pulse frequency command)
Basic parameter
Parameter
Name
Reference
P0-01
Control mode selection
5.7.1
P5-20
Servo ON signal /S-ON
5.2.1
P0-10
Pulse command form
5.3.2
P0-15
Command pulse frequency at rated speed
5.7.2
P0-16
Speed command pulse filter time
5.7.4
Other parameters
Key word
Parameter
Name
Reference
Proportion
action
P5-21
Proportion action command /P-CON
5.6.12
Zero clamp
P5-31
Zero clamp /ZCLAMP
5.6.6
P3-12
Zero clamp mode
P3-13
Zero clamp speed
Same speed
detection
P5-39
/V-CMP speed coincidence checking
5.6.8
P5-04
speed coincidence checking signal width /V-CMP
Torque limit
P3-28
Internal forward torque limit
5.6.7
P3-29
Internal reverse torque limit
P3-23
T-REF distribution
P3-30
Forward external torque limit
P3-31
Reverse external torque limit
P5-25
Forward external torque limit /P-CL
P5-26
Reverse external torque limit /N-CL
P5-42
Torque up to limit value output /CLT
Speed reach
detection
P5-51
Speed reach output /V-RDY
5.6.9
P5-05
Reach detection speed