Xinje XC3 Series User Manual

Appendix 1 special soft device list
ID Function Description
M8050
I000□
Forbid the input interruption 0
M8051
I010□
Forbid the input interruption 1
M8052
I020□
Forbid the input interruption 2
M8053
I030□
Forbid the input interruption 3
M8054
I040□
Forbid the input interruption 4
M8055
I050□
Forbid the input interruption 5
After executing EI instruction, even the
interruption is allowed, but if M acts at this
time, the correspond input interruption
couldn’t act separately
E.g.：when M8050 is ON, interrupt I000□ is
forbidden
M8056
I40□□
Forbid the time interruption 0
M8057
I41□□
Forbid the time interruption 1
M8058
I42□□
Forbid the time interruption 2
After executing EI instruction, even the
interruption is allowed, but if M acts at this
time, the correspond time interruption
couldn’t act separately
M8059
Forbid the interruption Forbid all interruption
ID Function Description
M8067 Operation error happen when calculating
M8070 Scan time out
M8071 No user program Internal codes parity error
M8072 User program error execution codes or configure table parity error
Interruption (M8050-M8059)
Error Testing (M8067-M8072)

Xinje XC3 Series Specifications

General

Series	XC3
Type	PLC
Communication Ports	RS232, RS485
Power Supply	24V DC
CPU Type	32-bit
Programming Software	XCP Pro
Operating Temperature	55°C
Analog Inputs	Optional, depends on expansion modules
Analog Outputs	Optional, depends on expansion modules