Wireless Access Point
The Command Line Interface 471
load
The load command [MyAP(config)# load] loads a configuration file.
location
The location command [MyAP(config)# location] is used to set the location
descriptive string for the AP.
Command Description
factory.conf Load the factory settings configuration file.
FORMAT:
load [factory.conf]
lastboot.conf Load the configuration file from the last boot-up.
FORMAT:
load [lastboot.conf]
[myfile].conf If you have saved a configuration, enter its name
to load it.
FORMAT:
load [myfile.conf]
saved.conf Load the configuration file with the last saved
settings.
FORMAT:
load [saved.conf]
Command Description
<cr> Set the location for the AP.
FORMAT:
location [newlocation]
To Next Page
Loading...
Need help?
General
