Wireless Access Point
The Command Line Interface 479
quick-config
The quick-config command is used to apply configuration templates to the AP
for typical deployment scenarios.
snmp Disable SNMP features.
FORMAT:
no snmp
spanning-tree Disable spanning tree.
ssh Disable ssh access.
FORMAT:
no ssh
syslog Disable the Syslog services.
FORMAT:
no syslog
telnet Disable Telnet access.
FORMAT:
no telnet
Command Description
Classroom Configure AP for classroom deployment.
FORMAT:
quick-config Classroom
Configures the AP for use in classroom settings
(K-12 schools, Higher education, etc.)
High-density Configure AP for high density deployment.
FORMAT:
quick-config High-density
Configures the AP for use in high density settings
(lecture halls, convention centers, stadiums, etc.)
Command Description
To Next Page
Loading...
Need help?
General
