Xsensor ForeSite SS - Page 27

ForeSite SS Hardware
23
If the sensor has one of the following
markings, it is cleanable as per the
Cleanable Sensor Instrucons secon
of this User Guide.
For sensors WITHOUT this label, place sensor in the approved
protecve sleeve provided by XSENSOR before placing on the desired
surface. Ensure that the protecve sleeve separates the porons of
the sensor pad that may come into direct connuous contact with the
subject. The cabling from the sensor to the sensor pack should exist
from the open end of the sensor protecve sleeve.
Figure 2
6. Power ON the tablet by pressing the ON/OFF buon for at least 3
seconds (Figure 3). The power LED indicator on the display panel will
turn blue. Once the tablet is powered ON, the green power light on
the SPK will turn green. See the ForeSite SS Soware secon of this
guide for details on using the soware.
7. The ForeSite SS system is now ready for use. Before the subject
makes contact with the sensor, ensure that they do not have any
sharp objects or protrusions that may puncture/tear the sensor pad
covering material.
Warning: Neither sensor pads nor protecve sleeves are intended for
contact with bare skin.
Figure 3
CLEANABLE
CLEAN ONLY AS
RECOMMENDED
IN USER GUIDE