Figure 10: Lower the pump while moving between anti-rotation gussets
7. Lift the pump slightly again, approximately 2–3 cm (1 in). Turn it counterclockwise until
the anti-rotation device on the hydraulic end lands against the nearest adjacent vanes.
2–3 cm (0.8–1.2 in.)
WS003677B
Figure 11: Turn the pump until the anti-rotation device is in place.
8.
Lower the pump to its final bottom position.
No more anchoring of the pump is required. Maximum permissible submersion depth is
20 m (65 ft).
4 Installation
36 P7030, P7035, P7040 Installation, Operation, and Maintenance Manual
To Next Page
Loading...
