Xylem FLYGT P7030 Series - Replace the Bellmouth

WS003616A
4. Tighten the propeller screw.
5. Tighten the propeller screw a further 1/8 turn (45°).
6. Check that the propeller can rotate freely.
6.9 Replace the bellmouth
1. Remove the three hexagonal screws securing the bellmouth.
If there are zinc anodes, then six hexagonal screws must be removed.
1
2
3
WS003763B
4
1. Hexagonal screws
2. Bellmouth
3. O-ring (optional)
4. Pump housing
2. Lift off the bellmouth.
3.
Put the new bellmouth in place.
The O-ring is delivered from the factory but does not need to be replaced after initial use.
6 Maintenance
P7030, P7035, P7040 Installation, Operation, and Maintenance Manual 75