b) Turn the adjustment screw 3/4 of a turn, so that it juts out from the sleeve
approximately 1.5 mm (0.06 in).
Use the trim tool.
c) Fit the sleeve onto the shaft.
d)
Carefully fit the propeller to the shaft.
Make sure that the sleeve and propeller are pushed on straight onto the shaft. If not
they might get stuck part way on.
3. Fit the propeller screw and washer.
6 Maintenance
74 P7030, P7035, P7040 Installation, Operation, and Maintenance Manual
To Next Page
Loading...
