Xylem FST - Control Panel Remote Operation; Data Log Download and Analysis

6.8.3.6 View or change the location details
1. Click the Settings tab.
2. On the Settings page, click the Location administration button.
3. On the Location administration page, select the name of the location from
the following lists to change details:
– Region
– Hub
– Customer
– Site
4. On the edit location page, change the location details as applicable.
5. Click the Update button.
6.8.3.7 Delete a location
1. Click the Settings tab.
2. On the Settings page, click the Location administration button.
3. On the Location administration page, select the name of the location from
the following lists to delete:
– Region
– Hub
– Customer
– Site
4. On the edit location page, click Delete.
6.8.4 Input output
6.8.4.1 Configure input output devices
1. Click the Settings tab.
2. On the Settings page, click the Input/Output admin button.
3. On the Input output configuration page, select the device name.
4. For the Digital input 1, select the input type and alarm status.
5. For the Digital input 2, select the input type and alarm status.
6. Click Next.
7. Set the Analog input 1 parameters.
8. Click Next.
9. Set the Analog input 2 parameters.
10. Click Next.
11. Select the values for the Output relay 1 and the Output relay 2.
This is for switching 120VAC, 5A devices. One relay is normally open and
the other is normally open and normally closed.
12. Click Save.
6 Operation
34 FST Installation, Operation, and Maintenance Manual