Table of Contents
1 Introduction and Safety............................................................................................ 3
1.1 Introduction........................................................................................................3
1.2 Safety terminology and symbols..................................................................... 3
1.3 User safety.......................................................................................................... 4
1.3.1 Power lock-out........................................................................................... 5
1.3.2 Qualification of personnel........................................................................ 5
1.4 End of life product disposal............................................................................. 5
1.5 Spare parts......................................................................................................... 6
1.6 Warranty..............................................................................................................6
1.7 Support............................................................................................................... 6
2 Product Description.................................................................................................. 7
2.1 Introduction........................................................................................................7
2.2 Features.............................................................................................................. 7
2.3 Parts.....................................................................................................................7
2.4 Extra parts...........................................................................................................8
3 Mechanical Installation............................................................................................. 9
3.1 Precautions......................................................................................................... 9
3.2 Prepare for an open engine unit......................................................................9
3.3 Prepare for an enclosed engine unit...............................................................9
3.4 Install the FST module.................................................................................... 10
4 Electrical Installation...............................................................................................13
4.1 Precautions.......................................................................................................13
4.1.1 Battery.......................................................................................................13
4.2 Cables............................................................................................................... 13
4.3 Connect the wiring harness to the control panel........................................ 14
4.4 Connect the I/O extension cable...................................................................15
4.5 Connect a flowmeter to the control panel................................................... 16
4.6 Connect the suction pressure transducer.................................................... 17
4.7 Connect the discharge pressure transducer............................................... 18
4.8 Connect a fuel level transducer.....................................................................19
4.9 Connect the sump level transducer.............................................................. 22
4.10 Connect devices to IO extension cable......................................................22
5 System Setup........................................................................................................... 25
5.1 Set the communication parameters..............................................................25
5.2 Set the miscellaneous parameters................................................................ 25
5.3 Set the digital input parameter......................................................................25
5.4 Set the analog input parameters...................................................................25
Table of Contents
FST Installation, Operation, and Maintenance Manual 1
To Next Page
Loading...
