1.3.1 Power lock-out
DANGER: Electrical Hazard
Before starting work on the unit, make sure that the unit and the
control panel are isolated from the power supply and cannot be
energized. This applies to the control circuit as well.
1.3.1.1 Battery
Check that the cable has been disconnected from the negative battery terminal,
as part of the power lock-out process.
1.3.2 Qualification of personnel
WARNING: Electrical Hazard
Risk of electrical shock or burn. A certified electrician must
supervise all electrical work. Comply with all local codes and
regulations.
All work on the product must be carried out by certified electricians or Xylem
authorized mechanics.
Xylem disclaims all responsibility for work done by untrained, unauthorized
personnel.
1.4 End of life product disposal
Handle and dispose of all waste in compliance with local laws and regulations.
1 Introduction and Safety
FST Installation, Operation, and Maintenance Manual 5
To Next Page
Loading...
