Xylem wtw Multi 3630 IDS - Page 85

Multi 3630 IDS Settings
ba77170e03 10/2017 85
Setting menu of the
VisoTurb
®
900-P
11.6 Sensor-independent settings
11.6.1 System
To open the Storage & config menu, press the <ENTER_> key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Menu item Possible
setting
Explanation
Calibration /
Calibration record
- Displays the calibration record of the
last calibration.
Calibration /
Calibration data
storage / Display
- Displays the last calibration records
(max. 10)
Calibration /
Calibration data
storage / Output to
USB flash drive or
printer
- Outputs the stored calibration data
to a connected USB memory device/
USB printer)
Calibration /
Calibration data
storage / Output to
RS232/USB
- Outputs the calibration data storage
to the interface
Calibration /
Calibration interval
1 ... 30 ...
999 d
Calibration interval for the turbidity
sensor (in days).
The meter reminds you to calibrate
regularly by the flashing sensor sym-
bol in the measuring screen.
Auflösung 0.1
1
Resolution of the FNU/NTU display
Reset - Resets all sensor settings to the
delivery condition (see section
11.7.1).
Menu item Setting Explanation
System / General / Language Deutsch
English
(more)
Selects the menu language
System / General / Acoustic signal on
off
Switches on/off the beep on keystroke
System / General / Illumination Auto
on
Switches the display illumination on/off