Yaesu FT-2000D - Connection of Microphone and Headphone

140 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Page 11FT-2000D OPERATING MANUAL

CONNECTION OF MICROPHONE AND HEADPHONE

INSTALLATION AND INTERCONNECTIONS

Table of Contents

General Description3
- Table of Contents4
Accessories & Options6
- Supplied Accessories6
- Available Options6
Before You Begin8
- Extending the Front Feet8
- Adjusting the Main Tuning Dial Torque8
- Resetting the Microprocessor9
Installation and Interconnections10
- Antenna Considerations10
- About Coaxial Cable10
- Grounding11
- Connection of Antenna and FP-2000 Power Supply12
- Connection of Microphone and Headphone13
- Key, Keyer, and Computer-Driven Keying14
- Interconnections14
- VL-1000 Linear Amplifier Interconnections15
- Interfacing to Other Linear Amplifiers16
Plug/Connector Pinout Diagrams17
Front Panel Controls & Switches18
Display Indications30
Rear Panel34
FP-2000 Switches & Jacks36
Basic Operation: Receiving on Amateur Bands37
- Operation on 60-Meter (5 Mhz) Band (U.S. Version Only)40
- CLAR (Clarifier) Operation on Main (VFO-A)41
- Lock42
- DIM42
Convenience Features44
- Dual Receive44
- P.BACK (Audio Playback) from47
- Main (VFO-A) Receiver47
  - P.BACK Feature from the Optional FH-2 Remote Control Keypad47
  - MY Bands" Operation48
- Band Stack Operation49
- Custom Switch)49
- Rotator Control Functions50
- More Frequency Navigation Techniques51
- Receiver Operation (Front End Block Diagram)52
- IPO (Intercept Point Optimization)53
- Att53
- RF Gain (SSB/CW/AM Modes)54
Advanced Interference-Suppression Features55
RF Front End55
- Using the VRF (Variable RF Front-End Filter)55
Interference Rejection (Signals off Frequency by Just a few Khz)56
- R.FLT (Roofing Filters)56
Interference Rejection (Signals Within 3 Khz)57
- CONTOUR Control Operation57
- IF SHIFT Operation58
- WIDTH (if DSP Bandwidth) Tuning59
  - Using if Shift and Width Together59
- IF Notch Filter Operation60
- Digital Noise Reduction (DNR) Operation61
- Digital Notch Filter (DNF) Operation61
- NARROW (NAR) One-Touch if Filter Selection62
- IF Noise Blanker (NB) Operation63
Tools for Comfortable and Effective Reception64
- AGC (Automatic Gain Control)64
  - SLOPED AGC Operation65
- Mute Feature (Main (VFO-A) Band)65
SSB/AM Mode Transmission66
Using the Automatic Antenna Tuner68
- ATU Operation68
  - About ATU Operation69
- Lithium Battery Replacement70
Enhancing Transmit Signal Quality71
- Adjusting the SSB Transmitted Bandwidth71
- Parametric Microphone Equalizer72
- Using the Speech Processor74
- Low- Distortion CLASS-A Operation76
Transmitter Convenience Features78
- Voice Memory78
  - Voice Memory Operation from the Optional FH-2 Remote Control Keypad79
- VOX (Automatic TX/RX Switching Using Voice Control)80
- Monitor80
- Split Operation Using the TX Clarifier81
- Split-Frequency Operation82
  - VFO Tracking Feature82
  - Quick Split Operation83
CW Mode Operation84
- Setup for Straight Key84
- (And Straight Key Emulation) Operation84
- Using the Built-In Electronic Keyer85
CW Convenience Features87
- CW Spotting (Zero-Beating)87
- Using CW Reverse88
- Audio Peak Filter89
- CW Delay Time Setting89
- CW Pitch Adjustment89
- Contest Memory Keyer90
  - Message Memory90
    - Transmitting in the Beacon Mode91
  - TEXT Memory92
    - Contest Number Programming93
    - Decrementing the Contest Number93
- Contest Memory Keyer94
- (Using the Optional FH-2 Remote Control Keypad)94
  - Message Memory94
  - TEXT Memory96
FM Mode Operation98
- Basic Operation98
- Repeater Operation99
- Convenient Memory Functions100
Memory Operation101
- QMB (Quick Memory Bank)101
- Standard Memory Operation102
- Memory Groups105
  - Memory Group Assignment105
  - Choosing the Desired Memory Group105
Operation on Alaska Emergency Frequency106
5167.5 Khz (U.S. Version Only)106
VFO and Memory Scanning107
- VFO Scanning107
- Memory Scan108
Pms109
Packet Operation110
- Packet Setup (Including Subcarrier Frequency)110
- Basic Setup110
RTTY (Radio Teletype) Operation111
- Setting up for RTTY Operation111
- Basic Setup111
Miscellaneous AFSK-Based Data Modes112
About the Transverter Output Terminal113
Menu Mode114
- Using the Menu114
- Menu Mode Reset114
- AGC Group118
- DISPLAY Group118
- DVS Group119
- KEYER Group119
- 021 Tey CW MEM1119
- 022 Tey CW MEM2119
- GENERAL Group120
- 023 Tey CW MEM3120
- 024 Tey CW MEM4120
- 025 Tey CW MEM5120
- S if SFT Group122
- MODE-AM Group122
- MODE-CW Group123
- MODE-DAT Group124
- MODE-FM Group125
- MODE-RTY Group125
- MODE-SSB Group126
- RX AUDIO Group126
- RX DSP Group127
- SCOPE Group128
- TUNING Group129
- TX AUDIO Group131
- TX GNRL Group131
Specifications134
Installation of the Optional Filter136
(Yf-122C & Yf-122Cn)136

Related product manuals

Preview: Yaesu FT-2000

Preview: Yaesu FT-2000/D

Yaesu FT-2000/D

Preview: Yaesu FT-2000 - MENU MODE LIST

Yaesu FT-2000 - MENU MODE LIST

Yaesu FT-2000D - MENU MODE LIST

FT-2000 - TRANSVERTER OUTPUT TERMINAL

Preview: Yaesu FT-209R

Preview: Yaesu FT-208R

Preview: Yaesu FT-252

Preview: Yaesu FT-2900R

Preview: Yaesu FT-2800M

Preview: Yaesu FT-2980R