Yaesu FT3DR - Page 63

61
Set mode no. / item Description
Selectable options
(
Options in bold are the default settings )
10 APRS RINGER Set the bell ring on/off when a beacon
or message is received.
Mic-E: ON / OFF
POSITION: ON / OFF
WEATHER: ON / OFF
OBJECT: ON / OFF
ITEM: ON / OFF
STATUS: ON / OFF
OTHER: ON / OFF
MY PACKET: ON / OFF
MSG: ON / OFF
GRP: ON / OFF
BLN: ON / OFF
MY MSG: ON / OFF
DUP.BCN: ON / OFF
DUP.MSG: ON / OFF
ACK.REJ: ON / OFF
OTHER MSG: ON / OFF
TX BCN: ON / OFF
TX MSG: ON / OFF
11 APRS UNIT Select the units for APRS display. POSITION: MM.MM' / MM'SS"
DISTANCE: km / mile
SPEED: km/h / knot / mph
ALTITUDE: m / ft
TEMP: °C / °F
RAIN: mm / inch
WIND: m/s / mph
12 APRS TX DELAY Set the data sending delay time. 100ms to 1000ms 300ms
13 BEACON INFO Set the transmission beacon
information.
AMBIGUITY: OFF / 1 digit / 2digit / 3digit /
4digit
SPD/CSE: ON / OFF
ALTITUDE: ON / OFF
14 BEACON INTERVAL Set a beacon automatic sending
interval.
30sec / 1min / 2min / 3min / 5min / 10min /
15min / 20min / 30min / 60min
15 BEACON STATUS
TEXT
Input setting for status text. S.TXT: ON / OFF
TX RATE: 1/1 to 1/8
TEXT: Text 1 to Text 5
16 BEACON TX Select automatic or manual sending
of beacon.
AUTO / MANUAL / (SMART)
17 COM PORT SETTING Set the COM port. STATUS: ON / OFF
SPEED: 4800 / 9600 / 19200 / 38400
INPUT: OFF / GPS
OUTPUT: OFF / GPS / WAY.P
WAYPOINT: NMEA9 / NMEA6 / NMEA7 /
NMEA8
Mic-E: ON / OFF
POSIT: ON / OFF
WEATHER: ON / OFF
OBJECT: ON / OFF
ITEM: ON / OFF
18 DIGI PATH Set the digital repeater route. P1 OFF
P2(1) 1 WIDE1-1
P3(2) 1 WIDE2-1 / 2 WIDE2-1
P4(2)1••••••--••/2••••••--••
P5(2)1••••••--••/2••••••--••
P6(2)1••••••--••/2••••••--••
P7(2)1••••••--••/2••••••--••
P8(8)1••••••--••to8••••••--••
19 GPS SETUP Select a datum used for the GPS
function.
DATUM: WGS-84 / Tokyo (Mean)
PINNING: ON / OFF
DGPS: ON / OFF
20 GPS POWER Turn the GPS function ON/OFF. GPS ON / GPS OFF