After a low battery alert was observed, the lock
was powered down and powered back up with
full battery.
Door Lock needs Time
set / RF Module Power
Cycled
Power to the lock was restored and the locks
RTC was cleared. The controller should set the
time to ensure proper logging.
Disabled user entered at
keypad
A disabled user pin code was entered at the
keypad
Valid user but outside of
schedule
A valid user can be both a normal user and a
non-Access user. If a non-access user is out of
schedule this alarm will be sent instead of the
non-access alarm.
keypad attempts exceed code entry limit
front escutcheon removed from main
Low Battery
Starting at 4.6V
Critical Battery Level Starting at 4.4V
Integrated BLE Auto Relock
Integrated BLE Auto Unlock
Integrated Homekit BLE Lock
Integrated Homekit BLE Unlock
¹ Deleting all user codes will also delete any associated schedules (year day and daily repeating scheduled pin codes) assigned to user codes.
² This requires additional Hardware and calibration within the Yale Access App.
³ The Yale lock also supports a 3
rd
low battery alarm: too low to operate. This alarm is sent out as a Battery Report (with value = 0xFF)
through the Battery Command Class. This is the last low battery alarm level before the product stops functioning. Starting at 4.2V (0x8104)
⁴ Needs Yale Access App setup.
To Next Page
Loading...
