DSP-AX620
DSP-AX620
12
● Operation procedure of DIAG menu and SUB-MENU
There are 14 MENU items and some SUB-MENU items as well.
DIAG menu selection
Main unit: Jog dial w(forward)/q(reverse)
Remote control unit: Cursor N(forward)/B(reverse) key
SUB-MENU selection
Main unit: DSP PROGRAM (forward)/EFFECT (reverse) key
Remote control unit: Cursor
M(forward)/<(reverse) key
Only the remote control keys indicated in the Menu List can be used to select a sub menu
directly.
● Functions available during DIAG
In addition to the DIAG menu, functions as listed below are available.
• Input selection, 6CH input
• Center/Rear/Sub-woofer level adjustment
• Muting
• Power on/off operation
• Master volume
* It is possible to confirm Menu No.12 “IF STATUS” while keeping the signal process (opera-
tion status) of each DIAG menu by using the INPUT MODE key of the main unit.
● Initial settings used to start DIAG function
Following initial settings are used when starting the DIAG function.
When the DIAG function is canceled, the settings before starting DIAG will be restored.
• Input : DVD (6CH INPUT OFF)
• Master volume : -40dB
• Center/Rear/Sub-woofer level : 0dB
• Audio mute : OFF
• Speaker settings
MAIN : LARGE
CENTER : LARGE
REAR : LARGE
BASS OUT : BOTH
MAIN LEVEL : Normal (0dB)
• DIAG menu : DSP THROUGH (1. ANALOG BYPASS)
EFFECT
DSP
PROGRAM
– +
To Next Page
Loading...
Need help?
General
