Yamaha DTX900 - Click Mode [CLICK]; Basic Procedure in the Click Mode

Reference
104
DTX900 Owner’s Manual
Click Mode [CLICK]
This chapter explains the Click mode called up via the [CLICK] button.
In the Click mode, you can set the Click (Metronome) related parameters such as Click Voice, time signature and tempo
for the entire DTX900. In addition, you can use the Groove Check function and Rhythm Gate function for rhythm train-
ing and practice.
Basic Procedure in the Click Mode
1
Press the [CLICK] button to enter the Click
mode.
2
Note the tab menus (corresponding to the
[F1] – [F5] and [SF1] – [SF3] buttons) to
find the desired function, then press the
relevant button to call up the desired dis-
play.
3
Move the cursor to each parameter, then
set the value by using the data dial, [INC/
YES] and [DEC/NO] button.
4
After setting, press the [ENTER/STORE]
button to store all the settings in the Click
mode, other than tempo, beat (time signa-
ture) and subdivide.
• All the settings in the Click mode will be lost if the power is turned
off without storing.
•Never attempt to turn off the power while the message “Please
keep power on” is shown on the display; otherwise, all the settings
in the Click mode may be lost.
NOTICE