Maintenance
97
ing device, inject the gear oil into the
gear oil drain screw hole.
7. Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
8. Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
9. Securely install the cooling water inlet
covers on both sides of the gear case
using the bolt and nut removed earlier.
EMU29313
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
Do not paint anodes, as this would render
them ineffective.
Recommended gear oil:
Hypoid gear oil SAE 90 or 80W-90, API
GL-5
Gear oil quantity:
F300AET 1.520 L (1.607 US qt, 1.338
Imp.qt)
F350AET 1.520 L (1.607 US qt, 1.338
Imp.qt)
FL300AET 1.310 L (1.385 US qt, 1.153
Imp.qt)
FL350AET 1.310 L (1.385 US qt, 1.153
Imp.qt)
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
Tightening torque:
2.0 Nm (0.2 kgf-m, 1.5 ft-lb)
6AW-9-25-1E0 97 ページ ２０１０年３月１６日 火曜日 午後５時４５分
To Next Page
Loading...
