Yamaha F300A - Specifications and Requirements; Technical Specifications

10
Specifications and requirements
EMU34520
Specifications
TIP:
“(AL)” stated in the specification data below
represents the numerical value for the alumi-
num propeller installed.
Likewise, “(SUS)” represents the value for
stainless steel propeller installed and “(PL)”
for plastic propeller installed.
TIP:
“*” means, select the engine oil referring to
the chart of engine oil paragraph. For further
information, see page 13.
EMU2821J
Dimension:
Overall length:
1029 mm (40.5 in)
Overall width:
633 mm (24.9 in)
Overall height X:
2006 mm (79.0 in)
Overall height U:
2133 mm (84.0 in)
Transom height X:
637 mm (25.1 in)
Transom height U:
764 mm (30.1 in)
Weight (SUS) X:
365.0 kg (805 lb)
Weight (SUS) U:
373.0 kg (822 lb)
Performance:
Full throttle operating range:
5000–6000 r/min
Maximum output:
F300AET 220.7 kW@5500 r/min
(300 HP@5500 r/min)
F350AET 257.4 kW@5500 r/min
(350 HP@5500 r/min)
FL300AET 220.7 kW@5500 r/min
(300 HP@5500 r/min)
FL350AET 257.4 kW@5500 r/min
(350 HP@5500 r/min)
Idle speed (in neutral):
650 50 r/min
Engine:
Type:
4-stroke V
Displacement:
5330.0 cm
3
Bore  stroke:
94.0  96.0 mm (3.70  3.78 in)
Ignition system:
TCI
Spark plug with resistor (NGK):
LFR6A-11
Spark plug gap:
1.0–1.1 mm (0.039–0.043 in)
Control system:
Remote control
Starting system:
Electric starter
Starting carburetion system:
Electronic fuel injection
Valve clearance (cold engine) IN:
0.17–0.23 mm (0.0067–0.0091 in)
Valve clearance (cold engine) EX:
0.31–0.37 mm (0.0122–0.0146 in)
Min. cold cranking amps (CCA/EN):
670.0 A
Min. rated capacity (20HR/IEC):
100.0 Ah
Maximum generator output:
49 A
Drive unit:
Gear positions:
Forward-neutral-reverse
Gear ratio:
1.73(26/15)
Trim and tilt system:
Power trim and tilt
6AW-9-25-1E0 10 ページ ２０１０年３月１６日 火曜日 午後５時４５分