Components
34
ECM00660
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
EMU35053
Cowling lock lever (turn type)
To remove the top cowling, turn the cowling
lock levers at the front and side to release
them and lift off the cowling. Reverse this
procedure when reinstalling the top cowling.
When installing the cowling, align the 3 posi-
tions of the grommets to fit the cowling in the
rubber seal.
When installing the cowling, check to be sure
it fits properly in the rubber seal.
Be sure to check that the gap between the
top cowling and the bottom cowling is even
all around the cowling. If the top cowling is
loose or the gap is not even, reinstall the
cowling.
EMU26462
Flushing device
This device is used to clean the cooling wa-
ter passages of the motor using a garden
hose and tap water.
6AW-9-25-1E0 34 ページ ２０１０年３月１６日 火曜日 午後５時４５分
To Next Page
Loading...
