Yamaha F300A - Checking Battery (for Electric Start Models); Connecting the Battery

Maintenance
98
TIP:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
EMU29323
Checking battery (for electric start
models)
WARNING
EWM01902
Battery electrolyte is poisonous and
caustic, and batteries generate explosive
hydrogen gas. When working near the
battery:
● Wear protective eye gear and rubber
gloves.
● Do not smoke or bring any other source
of ignition near the battery.
The procedure for checking the battery var-
ies for different batteries. This procedure
contains typical checks that apply to many
batteries, but you should always refer to the
battery manufacturer’s instructions.
NOTICE
ECM01920
A poorly maintained battery will quickly
deteriorate.
1. Check the electrolyte level.
2. Check the battery’s charge. If your boat
is equipped with the digital speedome-
ter, the voltmeter and low battery alert
functions will help you monitor the bat-
tery’s charge. If the battery needs charg-
ing, consult your Yamaha dealer.
3. Check the battery connections. They
should be clean, secure, and covered by
an insulating cover. WARNING! Bad
connections can produce shorting or
arcing and cause an explosion.
[EWM01912]
EMU35604
Connecting the battery
WARNING
EWM00572
Mount the battery holder securely in a
dry, well-ventilated, vibration-free loca-
tion in the boat. Install a fully charged bat-
tery in the holder.
NOTICE
ECM01124
Do not reverse the battery cables. Other-
ZMU05873
6AW-9-25-1E0 98 ページ ２０１０年３月１６日 火曜日 午後５時４５分