Operation
60
end of the cord into the engine shut-off
switch.
5. Press the Start/Stop button to start the
engine. The indicator for the starting en-
gine will come on. NOTICE: Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, release the Start/Stop
button, wait 10 seconds, then crank
the engine again.
[ECM02490]
If the clip is not installed to the engine shut off
switch, the buzzer will sound when the
Start/Stop button is pressed.
EMU36510
Checks after starting engine
EMU41360
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
ECM02250
If water is not flowing out of the cooling
water pilot hole at all times while the en-
6AW-9-25-1E0 60 ページ ２０１０年３月１６日 火曜日 午後５時４５分
To Next Page
Loading...
