Naming the Stereo Out and Bus Outs 107
01V96 Version 2—Owner’s Manual
Bus Outs
8
Naming the Stereo Out and Bus Outs
You can change the default Bus names (BUS1, AUX4, STEREO, etc.). It may be convenient
to name the buses “Monitor Out” or “Effect Send,” for example, so that you can easily iden-
tify the signal type.
1 Press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | Out
Name page appears.
You can specify Short names in the center column (
1) and Long (full) names in the right
column (
2).
When the Name Input Auto Copy check box (
3) is on, the first four characters of a
newly-entered Long name are automatically copied to the Short name. On the other hand,
a newly-entered Short name is automatically added to the beginning of the Long name.
You can reset all bus names to their default names by moving the cursor to the INITIALIZE
button, then pressing [ENTER].
2 Move the cursor to a name you wish to change, then press [ENTER].
The Title Edit window appears, which enables you to edit the name.
3 Edit the name, move the cursor to the OK button, then press [ENTER].
The new name is now effective.
Tip: The edited name is stored in the Output Patch library.
1 2
3
To Next Page
Loading...
Need help?
General
