Setting the Input Channels from the Control Surface 91
01V96 Version 2—Owner’s Manual
Input Channels
7
EQ’ing Input Channels
1 Press the [SEL] button or move the fader for the channel you wish to control.
2To control EQ for the currently-selected channel, press one of the following
buttons to select the band you wish to adjust:
• [HIGH] button.............HIGH band
• [H-MID] button...........HIGH-MID band
• [L-MID] button............LOW-MID band
• [LOW] button ..............LOW band
3 Use the SELECTED CHANNEL [Q], [FREQUENCY], and [GAIN] controls to
adjust the Q, frequency, and gain of the band selected in Step 2.
When the Auto EQUALIZER Display (page 231) check box is on, the 01V96 displays the
EQ/EQ Edit page.
If the check box is off, the parameter value currently being adjusted pops up.
See page 84 for more information on EQ.
Tip:
•Pressing and holding down the button selected in Step 2 resets the corresponding band gain.
•Pressing the SELECTED CHANNEL [HIGH] and [LOW] buttons simultaneously resets the
Q, frequency and gain for each band.
To Next Page
Loading...
Need help?
General
