43
Connecting to a network manually
Wired network connection
For a wired network connection, connect a standard shielded twisted pair (STP) network cable (straight, category 5 or higher; sold
separately) to the NETWORK jack on the rear panel.
1 Press OPTION.
2 Select in the option menu.
Select Network route setting>Wired and follow the
instructions in the display to complete setup.
Note
• When a router that does not support DHCP is used, use Network
Config in the option settings to configure network settings (####).
• To configure your router’s subnet mask manually, apply the same
subnet used by this unit to all devices (####).
OPTION
To Next Page
Loading...
Need help?
General
