REAR WHEEL
4-27
5. Tighten:
• Rear wheel axle
• Rear wheel axle pinch bolts
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼▼▼▼
a. Tighten the rear wheel axle “1” with the
damper rod holder (24 mm) “2”.
b. In the order pinch bolt “3” → pinch bolt “4” →
pinch bolt “3”, tighten each bolt to 16 Nm (1.6
m·kgf, 11 ft·lbf) without performing temporary
tightening.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
6. Install:
• Brake pad supports
• Brake pad insulator
(onto the left brake pad)
• Brake pad shims
(onto the brake pads)
• Brake pads
• Brake caliper retaining bolts
• Rear brake caliper
Refer to “REPLACING THE REAR BRAKE
PADS” on page 4-47.
7. Measure:
IP
Measure the distance “a” only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance “a”
(between the wheel sensor rotor “1” and
wheel sensor housing “2”)
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
T
R
.
.
Rear wheel axle
98 Nm (9.8 m·kgf, 71 ft·lbf)
Rear wheel axle pinch bolt
16 Nm (1.6 m·kgf, 11 ft·lbf)
Damper rod holder (24 mm)
90890-01328
YM-01328
1
2
a
b
c
3
d
e
T
R
.
.
Brake caliper retaining bolt
27 Nm (2.7 m·kgf, 19 ft·lbf)
2
1
3
4
To Next Page
Loading...
