Yamaha Vmax VMX17C 2009 - Installing the Air Filter Case and Intake Funnels

AIR FILTER CASE
7-9
EAS2S31007
INSTALLING THE AIR FILTER CASE AND
INTAKE FUNNELS
1. Install:
• Variable intake funnel lever shaft
T
IP
• To install the variable intake funnel lever shaft
into the lower air filter case, slide the bushing 1
“1” in the direction of the arrow.
• Face the cutout “a” in bushing 1 “1” downward.
2. Install:
• Variable intake funnels “1”
• Variable intake funnel seals “2”
T
IP
Be careful not to break the pin “a” on each vari-
able intake funnel seal “1” when installing the
seals.
3. Install:
• Lower air filter case gaskets “1”
T
IP
Make sure that the lower air filter case gaskets
“1” are seated in the lower air filter case grooves.
4. Check:
• Variable intake funnel movement
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Connect the intake funnel servo motor cou-
pler when installing the intake funnel servo
motor into the lower air filter case.
b. Set the main switch to the “ON” position. The
variable intake funnels “1” move into the
down position. Make sure that the lip of the
variable intake funnel seals “2” are seated in
the fixed intake funnels “3”. (illustration A)
c. Set the main switch to the “OFF” position.
The variable intake funnels “1” move into the
center position. (illustration B)
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
1
a
1
a
1
a
A. Down
B. Center
1
a
New
1
1
2
3
1
2
A B