Yamaha Vmax VMX17C 2009 - Installing the Exup Cables

ENGINE REMOVAL
5-8
EAS30360
INSTALLING THE EXUP CABLES
1. Adjust:
• EXUP servo motor pulley “1”
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼▼▼▼
a. Connect the EXUP servo motor coupler to
the EXUP servo motor.
b. Activate the diagnostic mode and select the
diagnostic code number “53”.
Refer to “FUEL INJECTION SYSTEM” on
page 8-33.
c. Set the engine stop switch to “”.
T
IP
Make sure that the EXUP servo motor pulley “1”
is in the closed position as shown.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲▲▲▲
2. Install:
• EXUP cable 1 “1”
• EXUP cable 2 “2”
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Install the EXUP cable 1 “1” onto the servo
motor pulley, and then install the cable onto
the right side of the EXUP bracket.
T
IP
• The correct installation position for the EXUP
cable 1 is identified by the casting mark “a” on
the EXUP servo motor.
• EXUP cable 1 is identified by a black adjusting
bolt “b”.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
3. Adjust:
• EXUP cables
Refer to “ADJUSTING THE EXUP CABLES”
on page 3-17.
7
4
3
17
16
18
8
9
2
1
13
11
12
14
15
15
6
10
20
19
21
5
1
2
1
A. EXUP servo motor pulley side
B. EXUP valve pulley side
1
2
1
2
a
A
b
B