REAR BRAKE
4-50
• Never use solvents on internal brake com-
ponents as they will cause the brake caliper
piston dust seal and brake caliper piston
seal to swell and distort.
• Whenever a brake caliper is disassembled,
replace the brake caliper piston dust seal
and brake caliper piston seal.
EAS22670
INSTALLING THE REAR BRAKE CALIPER
1. Install:
• Rear brake caliper bracket
• Rear wheel axle
IP
• Do not install the brake pad supports, brake
pads, brake pad insulator, brake pad shims,
and brake caliper.
• Align the slot “a” of the rear wheel sensor hous-
ing “1” with the projection “b” of the rear brake
caliper bracket “2”, and then assemble them.
• Fit the brake torque stop pin “3” on the swing-
arm into the slot “c” on the rear brake caliper
bracket.
• After assembling the rear wheel sensor hous-
ing and the rear brake caliper bracket, make
sure that the projection “d” on the housing is
aligned with the projection “e” on the bracket.
NOTICE
ECA14470
Make sure there are no foreign materials in
the wheel hub. Foreign materials cause dam-
age to the inner sensor rotor and wheel sen-
sor.
2. Tighten:
• Rear wheel axle “1”
• Rear wheel axle pinch bolts
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Tighten the rear wheel axle “1” with the
damper rod holder (24 mm) “2”.
b. In the order pinch bolt “3” → pinch bolt “4” →
pinch bolt “3”, tighten each bolt to 16 Nm (1.6
m·kgf, 11 ft·lbf) without performing temporary
tightening.
Recommended fluid
DOT 4
1
2
a
b
T
R
.
.
Rear wheel axle
98 Nm (9.8 m·kgf, 71 ft·lbf)
Rear wheel axle pinch bolt
16 Nm (1.6 m·kgf, 11 ft·lbf)
Damper rod holder (24 mm)
90890-01328
YM-01328
c
3
d
e
2
1
To Next Page
Loading...
