Yamaha Vmax VMX17C 2009 - Page 276

ENGINE REMOVAL
5-3
Disconnecting the leads and hose
Order Job/Parts to remove Q’ty Remarks
Right rider footrest assembly Refer to “REAR BRAKE” on page 4-41.
Drive shaft Refer to “SHAFT DRIVE” on page 4-91.
Shift arm Refer to “SHIFT SHAFT” on page 5-65.
Clutch pipe Refer to “CLUTCH” on page 5-48.
Starter motor assembly
Refer to “ELECTRIC STARTER” on page
5-44.
Fuel tank Refer to “FUEL TANK” on page 7-1.
Throttle bodies
Refer to “THROTTLE BODIES” on page
7-11.
Air induction system hoses
Refer to “AIR INDUCTION SYSTEM” on
page 7-19.
Thermostat inlet pipes Refer to “THERMOSTAT” on page 6-7.
Radiator assembly Refer to “RADIATORS” on page 6-1.
Water pump outlet pipe/Water pump inlet pipe Refer to “WATER PUMP” on page 6-11.
Oil cooler adapter Refer to “OIL COOLER” on page 6-5.
1 Ignition coil coupler 4 Disconnect.
2 Cylinder identification sensor coupler 1 Disconnect.
3 Crankcase breather hose 1
8
6
7
4
1
1
2
1
1
5
9
3
LT
LT
LT
28 Nm (2.8 m
•
kgf, 20 ft
•
Ibf)
T
.R.
18 Nm (1.8 m
•
kgf, 13 ft
•
Ibf)
T
.R.