YASKAWA DX200 - Page 23

3-14
165559-1CD
HW1481993
DX200 Standard Setup
3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
13. Touch the dialog box with “CFPP” on it. The file starts to be copied
from the CF to the “DiskOnChip” folder. It takes 60 seconds to copy
the data.
When it is copied from the USB, START lamp on the programming
pendant lights.
When it is copied from the CF, HOLD lamp on the programming
pendant lights.
14. When the dialog box indicating the completion of copy appears, touch
“OK” button at the right top of the dialog box to close the box.
Touch here. The data starts to be
written-in and the HOLD lamp on the
programming pendant lights while
writing.
<CF> <USB>
Touch here. The data starts to be
written-in and the START lamp on the
programming pendant lights while
writing.
<CF> <USB>
When “END (Success)” appears,
touch “OK” button to close the
dialog box.
23/44