YASKAWA DX200 - Page 24

3 Programming Pendant Setup
3.2 Setting Up the Programming Pendant
3-15
165559-1CD
HW1481993
DX200 Standard Setup
15. Turn OFF the DX200 main power supply. Then be sure to remove the
“CF/USB for operations” from the programming pendant.
The setup of the programming pendant has been completed.
SUPPLE-
MENT
When the data have not been copied correctly, the following
dialog box appears. Contact Yaskawa design division.
NOTE
Refer to Chapter 5 Initialization of System Configuration in
Maintenance Mode for details about putting the license
sticker.
Error display dialog box:
Click “OK” button to close
the dialog box.
“END (Failure)” appears.
Click “OK” button to close
the dialog box.
24/44