6 Mechanical Installation
16 YASKAWA TOEPC7106170VA GA800 600 V Drive Installation & Primary Operation
2. Loosen the front cover screws.
Figure 6.4 Loosen the Front Cover Screws
3. Push on the four tabs found on each side of the front cover, then pull the front cover forward to remove it from
the drive.
A - Pull forward to remove the front cover. B - Unhook the tabs found on the sides of the front
cover.
Figure 6.5 Pull Forward to Remove the Front Cover
4. Remove the front cover from the drive.
Figure 6.6 Remove the Front Cover
Reattach the Front Cover
Wire the drive and other peripheral devices then reattach the front cover.
Note:
Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
To Next Page
Loading...
