7 Option Card Installation
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide 157
Option Card
Installation
7
Connection Diagram of PG-X3
Refer to Table 51 for a detailed description of the option board terminal functions.
The positioning of jumper CN3 selects the PG encoder power supply voltage (5.5 V or 12 V). Select the voltage level for
the PG encoder connected to the option and motor. If the wrong voltage is selected, the PG encoder may not operate
properly or may become damaged as a result.
Refer to Setting the PG Encoder Power Supply Voltage on page 158 for details.
Figure 93 PG-X3 Option and PG Encoder Connection Diagram
Note: The PG-X3 Option reads a maximum input frequency from the PG of 300 kHz. Be sure to select a PG with an output pulse
frequency of maximum 300 kHz when operating at maximum speed.
Take the following steps to prevent erroneous operation caused by noise interference:
• Use shielded wire for the PG encoder signal lines.
• Use separate conduit or cable tray dividers to separate option control wiring, main circuit input power wiring, and
motor output power cables.
Interface Circuit
Figure 85
Figure 94 Interface Circuit (PG-X3)
<1> Ground the shield on the PG side and the drive side. If noise problems arise in the PG signal, remove the shield ground from one end of the
signal line or remove the shield ground connection on both ends.
U/T1
V/T2
W/T3
R/L1
S/L2
T/L3
A+
A
B
Z
B+
Z+
a+
a
b
z
b+
z+
FE
IP
IG
IP12
IP5
IG
TB1
SG
SD
TB2
PG
NC
CN5-B
or
CN5-C
A
pulse monitor signal
Ground wire
B
pulse monitor signal
Z pulse monitor signal
YASKAWA
Drive
PGX3
Option
CN3
M
FE
twisted-pair shielded line
main circuit terminal control circuit terminal
26LS32 level
26LS31level
PGX3
PG Encoder
A,B,Z
A+,B+,Z+
600 Ω
a,b,z
a+,b+,z+
SG
Monitor Signals
A,B,Z
A,B,Z
26LS31 level
TOEP_C710616_38H_7_0.book 157 ページ ２０１５年１１月１１日 水曜日 午後７時４０分
To Next Page
Loading...
