YASKAWA L1000A - Terminal Cover

3 Electrical Installation
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide 29
Electrical Installation
3
◆ Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
■
Removing/Reattaching the Terminal Cover
Removing the Terminal Cover
Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027
1. Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 8
Figure 8 Removing the Terminal Cover
2. Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 9
Figure 9 Removing the Terminal Cover
Models CIMR- LU20085 to 20415, 40045 to 40605, and 50003 to 50027
1. Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models.
Figure 10
Figure 10 Removing the Terminal Cover
YEA_common
YEA_common
YEA_common
TOEP_C710616_38H_7_0.book 29 ページ ２０１５年１１月１１日 水曜日 午後７時４０分