Transportation
3 - 15
3.2 Shipping brackets and bolts
NOTICE
Before turning ON the power, check to be sure that the shipping bolts and brackets are
removed.
After removing the transport securing devices and the shipping bolts, keep them at a safe
place. The transport securing devices and shipping bolts will be required again if the system
is transported again.
The robot is equipped with transport securing devices and shipping bolts (see A and B as
shown in the following figure “Transporting Position“) for to reduce external forces to
minimum during transport.
The shipping brackets and bolts are painted yellow.
Fig. 3-3: Position of shipping bolts
Position Screw type Pcs
A Screw M6 (length: 10 mm, Strength category 12.9). 2
B Screw M5 (length: 14 mm, Strength category 12.9). 6
#
$
To Next Page
Loading...
