YASKAWA MOTOMAN-ES200RN - Grease Replenishment for Balancer Connection Part

9.2 Notes on Maintenance Procedures
9-20
HW0482143
9.2.5 Grease Replenishment for Balancer Connection Part
Fig. 28 Balancer Connection Part
1. Remove the hexagon socket head cap screw M6 and hexagon socket head plug PT1/8
from the grease inlets and exhaust ports of connection  and . (Refer to " Fig. 28
Balancer Connection Part ".)
2. Install the grease zerk A-PT1/8 on the grease inlets of connection  and  and inject
grease into the grease inlets using a grease gun.
Grease type: Alvania EP grease 2
Amount of grease: 5cc
(10cc for 1st supply)
The exhaust ports  and  are used for air flow.
Do not inject excessive grease into the grease inlets.
Exhaust port
Hexagon socket head plug PT1/8
Connection
Grease inlet
Hexagon socket head plug PT1/
Connection
Needle bearing (2 bearings)
Connection
Grease inlet
Hexagon socket head plug PT1/8 (2 plugs)
Exhaust port
Hexagon socket head cap screw M6 (2 screws)
Connection
Tapered roller bearing (2 bearings)
2
2
1
1
1
2
NOTE
66/71
HW0482143