4 I/O Signal Allocation
4.1 Setting of Optional Board and I/O Module
4-1
HW1483854
HW1483854
4 I/O Signal Allocation
4.1 Setting of Optional Board and I/O Module
In order to use the J71GF11-T2 board on the YRC1000, perform the
setting of the optional board and I/O module in the following procedure.
Before setting the optional board and I/O module;
1. Make sure that the power supply of the YRC1000 is turned OFF.
2. Insert the J71GF11-T2 board into the PCI Express slot on the
YRC1000. For the board mounting, refer to chapter 3 “Mounting the
J71GF11-T2 Board” .
1. Turn ON the power supply while pressing [MAIN MENU].
– The main menu appears.
2. Set the security mode to the “MANAGEMENT MODE”.
3. Select {SYSTEM} under the main menu
– The sub menu appears.
Set the optional board and I/O module in the management
mode.
In the operation mode and the editing mode, the settings are
for reference only.
To Next Page
Loading...
