YASKAWA MOTOMAN Series - Error Indication and LED Status; LED Indicators

6 Error Indication
6.1 LED Indicators
6-1
HW1483854
HW1483854
6 Error Indication
6.1 LED Indicators
LEDs are provided on the front of the J71GF11-T2 board to indicate the
status of CC-Link IE Field communications.
Name Contents and Remedy
Operation LEDs
Indicate the CC-Link IE Field operation status.
The LED lightning status is indicated in two modes: the RUN LED is Lit or Unlit and the RUN
LED is Flashing.
(1) When the RUN LED is Lit or Unlit
LED
name
Status Contents Remedy
RUN Lit Operated normally.
Unlit Either one of the following errors
has occurred.
•Turn OFF the power of YRC1000
then back ON to restart it.
•Check the connection status
between the J71GF11-T2 board and
the PCI slot of YRC1000.
•Replace the J71GF11-T2 board.
A hardware error or a board WDT
error has occurred.
The driver is not activated.
ERR.
Lit Either one of the following errors
has occurred.
•Turn OFF the power of YRC1000
then back ON to restart it.
•Check the connection status
between the J71GF11-T2 board and
the PCI Express slot of YRC1000.
•Replace the J71GF11-T2 board.
Errors have been detected in all
stations.
The identical station number exists
in the network.
The network parameter is broken.
The network parameter is different
from the mounting. (the reserved
station setting, the station number,
the network number etc.)
Flashing
Abnormal stations in the data link
have been detected.
•Check the operation status of the
master device.
•Verify the other connected devices
are turned ON.
•Check the wirings are not in the
following status.
(1)Both PORT1 and PORT2 are
connected to the switching hub.
(2)The Ring connection when the
loop back function is not used.
(3)The Star connection when the
loop back function is used.
(4)The incorrect Ring connection.
(5)Using the switching hub and
cable which do not correspond to
1Gbps.
•Check the station number is not
duplicate with the other station
numbers.
•Turn OFF the power of YRC1000
then back ON to restart it.
Unlit Operated normally.
SD Lit Data are being sent.
Unlit Data have not been sent.
RD Lit Data are being received.
Unlit Data have not been received.
ERR.
RUN
SD
RD
51/53