EasyManuals Logo

YASKAWA MP2000 Series User Manual

YASKAWA MP2000 Series
557 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #484 background imageLoading...
Page #484 background image
12.4 List of Causes for Command Error Occurrence
12-31
Troubleshooting
* When Automatic Updating of Parameter was enabled for fixed parameters, and the settings of Filter Time Constant,
Acceleration Rate/Time Constant, or Deceleration Rate/Time Constant were changed at the time a move command
was set.
26
Change Position Loop
Integral Time Constant
(KIS)
An alarm is occurring.
Asynchronous communication status
A: Servo Driver Synchronization
Communications Error
SERVOPACK parameter writing was not com-
pleted within the specified time.
A: Servo Driver Command Timeout
Error
Warning A.94 or A.95 occurred in the SERVO-
PACK.
W: Servo Driver Error
27
Stored Parameter Write
(PPRM_WR)
An alarm is occurring.
Asynchronous communication status
A: Servo Driver Synchronization
Communications Error
SERVOPACK parameter reading was not com-
pleted within the specified time.
A: Servo Driver Command Timeout
Error
Warning A.94 or A.95 occurred in the SERVO-
PACK.
W: Servo Driver Error
SERVOPACK parameter number or size is outside
the setting range.
W: Set Parameter Error
39
Multiturn Limit Setting
(MLTTRN_SET)
The command was used for a SERVOPACK that
doesn’t support it.
Executed while servo was ON.
Asynchronous communication status
A: Servo Driver Synchronization
Communications Error
The command to the SERVOPACK was not com-
pleted within the specified time.
A: Servo Driver Command Timeout
Error
Others
Automatic Parameter
Updating when Move
Command Starts
*
An alarm is occurring.
Asynchronous communication status
A: Servo Driver Synchronization
Communications Error
SERVOPACK parameter writing was not com-
pleted within the specified time.
A: Servo Driver Command Timeout
Error
Warning A.94 or A.95 occurred in the SERVO-
PACK.
W: Servo Driver Error
The distribution was not completed (DEN = OFF).
(cont’d)
Motion Command Code Cause of Command Error Occurrence
Warning (W:) and Alarm (A:) That
Occur at Command Error Occurrence

Table of Contents

Other manuals for YASKAWA MP2000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YASKAWA MP2000 Series and is the answer not in the manual?

YASKAWA MP2000 Series Specifications

General IconGeneral
BrandYASKAWA
ModelMP2000 Series
CategoryController
LanguageEnglish

Related product manuals