EasyManua.ls Logo

YASKAWA MP2000 Series - Page 547

YASKAWA MP2000 Series
557 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix J Terminology
A-45
Appendices
Finite Length Position Control
This control method is used to perform position control within a specified section for movements such as go-and-return
motions.
Refer to 5.1.3 Axis Type Selection for details.
Work Coordinate System
The coordinate system used in motion programs. It is called the Work Coordinate System to distinguish it from the
Machine Coordinate System. The work coordinate system can be set by executing the Change Current Value (POS)
instruction of the motion program.
Refer to Machine Controller MP900/MP2000 Series User’s Manual Motion Programming (manual number: SIEZ-C887-
1.3) for details.

Table of Contents

Other manuals for YASKAWA MP2000 Series

Related product manuals