What to do if AC high frequency 1 is detected on my YASKAWA SOLECTRIA XGI 1500 Inverter?
Using a CAT III multi-meter verify the AC frequency. If there is a discrepancy of greater than 2% between the measured results and the frequency detected, contact Technical Support.
What to do if an ARC fault is detected in my YASKAWA SOLECTRIA XGI 1500?
If a DC series arc fault has been detected in the PV array, inspect for and repair damage to the PV array and DC wiring. Clear the ARC Fault and retest. If the inverter doesn’t clear the error, contact Technical Support.
Why is there excessive leakage current in my YASKAWA SOLECTRIA XGI 1500 Inverter?
Excessive leakage current indicates a ground fault condition where the leakage current is greater than the allowable limit. Check the array for an unintentional reference to ground.
What to do if islanding is detected in my YASKAWA SOLECTRIA XGI 1500?
If an islanding condition has been detected, the inverter will cease production until the event has ended. Using a CAT III multi-meter, verify the AC voltage. If an islanding condition (no AC voltage) is identified, check all AC fuses or breakers.
What does it mean when the isolation resistance is low in my YASKAWA Inverter?
Low isolation resistance indicates a ground fault condition where the insolation resistance between the DC conductors and ground is below the allowable limit. Check the array for an unintentional reference to ground.
What to do if a communication fault initialization fault occurs on my YASKAWA SOLECTRIA XGI 1500?
Power cycle the inverter. If the inverter doesn’t clear the error, contact Technical Support.
What to do if communication failure 1 occurs on my YASKAWA SOLECTRIA XGI 1500 Inverter?
Power cycle the inverter. Contact Technical Support.
What to do if communication failure 2 occurs on my YASKAWA Inverter?
Power cycle the inverter. Contact Technical Support.
What to do if there is an internal over current or over voltage in my YASKAWA Inverter?
Power cycle the inverter. If the inverter doesn’t clear the error, contact Technical Support.
What to do if the operational self-check fails on my YASKAWA Inverter?
If the inverter self-diagnostic check has failed during operation, power cycle the inverter. If the inverter doesn’t clear the error, contact Technical Support.
General| Category | Inverter |
|---|---|
| Model | XGI 1500 Series |
| Type | Grid-tied |
| Maximum AC Power Output | 1500 kVA |
| Max. AC Output Power | 1500 kVA |
| Max. DC Input Voltage | 1500 VDC |
| AC Output Voltage | 600 VAC |
| Output Voltage | 600 VAC |
| Operating Temperature Range | -20°C to +50°C |
| Operating Temperature | -20°C to +50°C |
| Storage Temperature | -40°C to +70°C |
| Protection Features | DC Overvoltage, DC Overcurrent, AC Overvoltage, AC Overcurrent, Ground Fault, Anti-Islanding |
| Communication Interface | Ethernet, Modbus TCP |
| Humidity | 0-95% non-condensing |
| Enclosure Rating | NEMA 3R |
| Output Power | 1500 kVA |
To Next Page